Reset Methode for Canon Printers i6100, i255, i320, i550, i560, i850, i860, i865, i950, i9100, i9950
Canon i255, i320 Waste Ink Counter Reset
Step 1 : Manual for service mode
-
Unplug power and USB.
-
Open door and hold power button.
-
Connect power.
-
Close door, then release power button.
or Step 1: Manual for service mode
-
Turn off the printer. And disconnect the printer cable.
-
Press and hold the POWER button, turn on the printer.
-
The indicator LED should be green.
-
Press and release the RESUME button , the indicator LED should be orange.
-
Press and release the RESUME button again, the indicator LED should be green.
-
Release both buttons.
Step 2 : Software for Permanant
-
Reconnect the printer cable.
-
Download and Run General Tools software resetter for Canon printers i320, i255 then
-
select USB PORT
-
Choose SET DESTINATION 1 And it should be reset.
Remark “After service mode Pls use software for permanent reset”
Reset Procedures for Canon i550, i560, i850, i860, i865, i9100, i9950 Printers
-
Turn off Canon i550, i560, i850, i860, i865, i9100, i9950 Printers
-
Hold down Resume button and press Power button.
-
Keep holding down Power button and let Resume button go.
-
Press Resume button 2 times then let BOTH buttons go.
-
Green lights will flash and then stop blinking.
-
When green lights are solid, press the Resume button 4 times.
-
Press the Power button and the printer should turn off, if not, press the Power button once more.
-
Your Canon i550, i560, i850, i860, i865, i9100, i9950 Printers should respond as normal.
Canon i850, i950, Waste Ink Reset
-
Start with the printer OFF
-
Hold down RESUME and then hold down POWER
-
release RESUME
-
press RESUME twice, then release POWER
-
Let green light blink until printer is done futzing
Select function with RESUME press POWER to execute:
presses - light color - function
| Number of presses | light color | function |
| 0 presses | green | Test print (or exit service mode on i960) |
| 1 press | orange | EEPROM info print (plus grid nozzle diagnostic on i960) |
| 2 presses | green | EEPROM initialize |
| 3 presses | orange | Reset waste ink counter |
Reset Procedures Canon i6100
-
Turn off the printer
-
Press and hold RESUME button, then press and hold POWER button
-
Release the RESUME button
-
Next press and release the RESUME button two more times in succession, then release POWER button.
-
Press RESUME button for 4 times, this will select the clear waste ink counter function, The lamp will alternate color with each key press.
-
-
Service/Factory test printout, including ink sensor check.
-
EEPROM - Info printout.
-
EEPROM – Initialization.
-
Reset the Waste ink counter.
- Printer model setting. (More selections beyond this point – However it is best leave them unaltered – You have been warned!)
-






Leave a Reply