Disable Low Ink Warning in The Hp Deskjet

This tips working on my hp printer, I try this method on my hp deskjet 2466 and hp deskjet 2180 all in one and working 100%. To disable low ink warning in the hp printer following this steps :

  • Open system configuration utility by click start-run then type msconfig
  • Go to Startup Tab then disable HPWuSchd2 and HP Digital Imaging

  • Click apply then Ok
  • You must restart the computer to take effect

for other hp printer maybe also can use this methode to disable low ink warning.

Good luck. Happy resetter


Message reset methods for HP 4000, 4050, 4100, 5000, 4500, 4550

Printers HP 4000, 4050, 4100, 5000 Message Reset Methods

  • Turn the printer off
  • Hold down the left side of the ITEM and VALUE +/- keys
  • turn the printer on and wait until RESET MAINTENANCE COUNT is displayed
  • then release the keys

Printers HP 4500, 4550 Message Reset Methods

  • Turn the printer off
  • Hold down the CANCEL JOB and SELECT keys and turn the printer on, then wait until the display goes blank and the three LED’s come on
  • Press the right side of the MENU key, then press the SELECT key
  • You will enter SERVICE MODE after the normal test completes
  • Press the ITEM key until the FUSER MAINTENANCE COUNT appears
  • Press VALUE +/- to change to zero
  • Press SELECT to save
  • Press GO; the printer should return to READY

Cold reset and reset NVRAM HP LaserJets 1100, 1200, 2100, 2200

Printers HP LaserJets 1100, 1200

While the HP LaserJets 1100, 1200 printers is on, press and hold the Go button for 5 seconds. This will reset the printer.

To reset the NVRAM.

  • Turn the HP LaserJets 1100, 1200 printers off
  • Press and hold the Go button for 20 seconds while powering on the printer.

Printers HP LaserJets 2100

To perform a cold reset,

  • Turn the HP LaserJets 2100 printer power off
  • Press and hold the JOB CANCEL button.
  • Turn the printer power back on and after all the LEDs come on release the JOB CANCEL button. A cold reset changes most system parameters in NVRAM to the factory defaults. The JOB CANCEL button must be released within 20 seconds after all of the LEDs come on; otherwise, an NVRAM initialization is performed instead of a cold reset.

Reset Instructions for Printers HP 2200 LaserJets

Read the rest of this entry »





Links : |

Computer Blogs - Blog Catalog Blog Directory Top Computers blogs Computers Blogs - Blog Top Sites Computers Top Blogs Blogroll.net TopOfBlogs