Tricks-Collections.Com

Lexmark Optra SC 1275, Color 1200 Maintenance Message Reset Methods

1. Turn the printer off
2. Hold down the GO and RETURN keys while powering on the printer until PERFORMING SELF TEST is displayed
3. When REGISTRATION is displayed, press the right side of the MENU key six times until MAINTENANCE is displayed
4. Press the SELECT button, and then press the right side of the menu button to scroll to 80 or 81 RESET
5. Press the RETURN button until the display reads MAINTENANCE
6. Press the right side of the MENU button until the display reads EXIT DIAGNOSTICS
7. Press the SELECT button to return to the normal mode

Lexmark Optra T All Models Reset Methods

1. Turn the printer off
2. Enter the Configuration Menu by holding down the SELECT and RETURN buttons while powering on the printer until the display reads PERFORMING SELF TEST. After the self test, the display will read CONFIG MENU
3. Press the right arrow side of the MENU button until MAINTENANCE PAGE COUNT is on the display
4. Press the SELECT button. RESET should be displayed
5. Press the SELECT button again to reset
6. Press the RETURN button to return to the Configuration Menu and press the left arrow side of the MENU button to exit the Configuration Menu

Maintenance Message Reset Methods Optra S, 2420, 2450, 2455, 3455

1. Turn the printer off
2. Enter the Diagnostics Mode by holding down the GO and RETURN buttons while powering on the printer until the display reads PERFORMING SELF TEST. When ready, the display will read PRINT REGISTRATION
3. Scroll to PRINTER SETUP and press the SELECT button
4. Scroll to MAINTENANCE PAGE COUNT and press the SELECT button
5. Scroll to RESET MAINTENANCE COUNT and press the SELECT button to reset the count to zero
6. Press the RETURN button to return to the Diagnostics Mode main menu, then exit Diagnostics Mode to return to normal mode

Maintenance Message Reset Methods for Lexmark Optra W810

1. Enter the Configuration Menu by holding down the SELECT and RETURN buttons while powering on the printer until the display reads PERFORMING SELF TEST. After the self test the display will read CONFIG MENU
2. Press the right arrow side of the MENU button until MAINT. COUNTER is displayed
3. Press the SELECT button, then scroll to RESET TRANSFER or RESET FUSER and press the SELECT button again to reset
4. Press the RETURN button to return to the Configuration Menu and press the left arrow side of the MENU button to exit the Configuration Menu

Maintenance Message Reset Methods for Laser Printer 10R/10 Plus, 12 Series, 16 Series, Optra R L

1. Turn the printer off
2. Enter the Diagnostics Mode by holding down the READY and RETURN buttons while powering on the printer until the display reads PERFORMING SELF TEST
3. Select MAINTENANCE COUNT
4. Select RESET to return the count to zero
5. Press the RETURN button to return to the Diagnostics Mode main menu, then reset printer to return to normal mode

Error Codes and Solutions for Lexmark Printers

22 Paper Out or Paper Jam

• Check for paper in the paper tray
• Check the size of the paper in the paper tray to see if it is the same as what the printer is set for.
• Defective D-roller
• Debris in the paper path
• Gears not turning or broken gear
• Defective paper tray
• Broken input sensor flag
• Defective input sensor board
• Defective system cable 2
• Defective system board

23 Paper Jam

Same as 22 with these additions:
• Exit Sensor flag (Fuser)
• Exit Sensor board (Fuser)
• System cable 1

24 Invalid Manual Feed

• Paper feed into the Manual feed when printer is pulling paper off paper tray
• Don’t feed paper in the manual feed unless requested
• See 23

Read the rest of this entry »